Note : the command monitor-interface only allows you to monitor interfaces that have been configured with nameif. ![]() Interface port-channel 1.1000 port-channel min-bundle 2 Below shows the necessary commands, monitor-interface port-channel 1.1000 To ensure a device-level failover occurs in the event of a single member link failure the port-channel min-bundle command is used. Meaning that even if you are monitoring the port-channel if a single link goes down within the bundle it will not trigger a device-level failover. interface GigabitEthernet0/1īy default when you configure a port channel the port channel will remain up as long as there is one active member interface. Configurationīelow shows the configuration to create am EtherChannel that will act as a trunk with the VLAN 1000 enabled. ![]() Within this article we will provide the steps required to create an Etherchannel link on the Cisco ASA along with providing the main troubleshooting/show commands. An Etherchannel provides a method of aggregating multiple Ethernet links into a single logical channel. ![]() The ability to configure EtherChannels on ASA models 5510 and above was introduced within 8.4/8.6.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |